Echo Blaster 64, Echo Blaster 128, LogicScan 64 and LogicScan 128 installation/re-installation process.


1) Be sure that USB cable disconnected from beamformer.
2) Un-install all previously installed Echo Blaster/LogicScan drivers and Echo Wave/Echo Wave II.
3) Run installation of "TELEMED Drivers Package".
4) Choose necessary system (Echo Blaster 64, Echo Blaster 128, LogicScan 64 or LogicScan 128).
5) Finalize drivers installation (*).
6) Connect USB cable to beamformer.
7) Windows operating system will find new device, let Windows to find drivers automatically.
8) Install "Microsoft .NET Framework 2.0" (Windows XP only).
9) Install Echo Wave or Echo Wave II (or both on same computer).
0) Run Echo Wave / Echo Wave II, ultrasound system must work properly.


* Note regarding drivers installation: A pop-up message will appear (stating the driver is
   not digitally signed by Microsoft). You will need to acknowledge this message (by clicking
   "Continue Anyway / Allow", not "Cancel") to proceed with driver installation.


(c) 2008 TELEMED
Internet: http://www.telemed.lt
Information e-mail: info@telemed.lt
TechSupport e-mail: support@telemed.lt